3D CAD NEWS

The ignoble Pushmi-Pullyu (“push-me pull-you”) is a two-headed beast made famous by the Doctor Doolittle stories of the 19^th Century. The mythical animal is noted for its ability to do either two things at once or struggle to do nothing, and to oscillate between these two extremes. Our 21^st Century CAD equivalent is history-free feature-based 3D modeling. For years a few vendors struggled to gain market share with it (CoCreate and Kubotek come to mind), but suddenly Pushmi-Pullyu CAD has become the rage.

SpaceClaim got way more press than it deserved for its new “natural 3D design system” last year, then PTC embraced its inner pushmi-pullyu by buying CoCreate. Today Siemens PLM Software becomes the latest CAD company to abandon the CAD Reich gospel of parameters uber alles with the introduction of what it calls synchronous technology (as if there is something mysteriously asynchronous about using existing 3D CAD tools; but we digress).

The Pushmi-Pullyu, new mascot of Siemens PLM Solutions

No less an authority on these things than Dr. Ken Versprille, the father of NURBS and resident PLM guru at CPDA, says in a published quote (I’ll bet a dollar he was paid to write), “its ability to recognize current geometry conditions and localize dependencies in real time allows synchronous technology to solve for model changes without the typical replay of the full construction history from the point of edit.”

Ken's quote is a real mouthful, so let us translate for the SolidWorks bloggers among our readership: You don’t have to redraw the damn part to make a single damn change all the damn time anymore. The good doctor goes on to say that “… users will see dramatic performance gains. A 100 times speed improvement could be a conservative estimate.”

Wow! Models 100x faster than with Autodesk Inventor and probably 300x faster than CATIA? Siemens resellers must be doubled over with orgasmic spasms at the mere suggestion of such superior results, especially because this new technology will be added to both NX and Solid Edge. Maybe Solid Edge will actually sell some copies again.

When you get the previous word picture washed out of your mind, let us consider something a bit more serious. CAD pundits (self glamourously included as shown below) refer to the Big Four CAD Vendors: Autodesk, Dassault Systemes, Siemens PLM, and PTC. A year ago not one of these had history-free feature-based modeling; now two do. Not that long ago Autodesk and Dassault entered into a bidding war over Seemage; perhaps SpaceClaim just might survive long enough to be so lucky.

A self-proclaimed Leading CAD Pundit caught in the act of meditating on synchronous technology at COFES 2008.